C1554
“Offshore Seamist
Rising”
(Bandon
Beach, Oregon Coast)
Oil Sketch on Centurion Oil Primed Linen Panel
With additional coat of Rublev Lead Primer
5” x 7”
Although there was still a
wind from the North, it was not as strong as it has been for the past weeks,
more of a stiff breeze, but I was determined to start painting the sea-stacks
on Bandon Beach. I decided to work below
the south facing cliff of a promontory, where I painted once before last
November. There is a little ledge
keeping one off the sand, and with a little overhang to keep the Sun off for
part of the time. The wind was gusty
enough that fine sand sifted down from the cliff top throughout my painting
session, and by the time I had finished it seemed as though I had been painting
with sand. I was not unduly worried
since I have had this happen before, admittedly to a lesser extent. Two days later when the work was touch dry I
was able to brush off most of the sand from the sky and sea, and left a bit on
the cliff and beach in the foreground to add texture. The more stubborn flecks I disposed of with
the judicious use of the tip of a scalpel blade … a very useful tool. Perhaps I should have left more on as
souvenirs. It was a generally sunny day
with cloud coming and going, and for the first part of the session there was an
off shore bank of sea-mist moving from north to south with the breeze, which I
was able to capture. It never came onto
shore, which I half expected, but remained out on the water just beyond the
sea-stacks I was painting.
Again I chose to lay down
an imprimatura of Venetian Red, which
was perfect in adding a warmth glowing through the cooler pigments brushed over
it when depicting the rising bank of fog.
I used a bristle brush throughout, capitalizing upon its ability to add
interesting texture to the painted surface.
In my Watercolour work I sometimes add interest to areas of a painting
by building up thin layers with dry-brushed strokes and crosshatching using
older brushes and splaying their hairs sort of like a leaf rake in shape; I’m
getting a similar effect with the bristle brush lightly applying he paint at a
shallow angle to the surface.
The
rest of the pigments used were Cerulean & Cobalt Blues, a little bit of
Ultramarine Blue, Yellow Ochre, Venetian Red, and Cremnitz & Titanium
Whites. Cerulean is used mainly in the
sky & sea, with perhaps a little Cobalt Blue added, however Cobalt Blue is
mainly used to make the lovely greys when combined with Venetian Red. When a deeper toned grey is required, then
Ultramarine replaces the Cobalt Blue in the mixture. To be honest Ultramarine could replace Cobalt
Blue throughout, but I like the softer greys produced with the Cobalt, as well
as the quieter greens it produces. A
couple of minute touches of Cadmium Yellow Pale, hinted at the yellow flowers
in the grasses on the top of the right hand island.
No comments:
Post a Comment
Thank You for your comments. If you have read "the Journey" Tab you will know that my time online is usually limited; I trust you will understand that I may not be able to reply to comments or specific questions, but that perhaps they might be addressed in future posts.